Small Scale Banner Set (G) – Large Waist Type suits Adeptus Titanicus / Epic etc

(1 customer review)


In stock

SKU: SBAN-G Categories: ,


This set is printed to a high standard in ceramic gray photopolymer resin.

Supplied unpainted and unassembled.

This 6 part set consists of 3 16mm wide Banners and Hangers.

Revised design – this kit is now printed in resin with pre-curved banners and finer detail than previous versions.

This set can be used either with printed paper banners or using the pre-curved resin banners.

Cleanup will be required and is most easily done with a sharp, new #11 x-acto blade.

Miniatures pictured are not included, and are for illustrative purposes only.

Designs are under constant revision and improvement. As such, the product may vary slightly from pictured.


1 review for Small Scale Banner Set (G) – Large Waist Type suits Adeptus Titanicus / Epic etc

  1. Edward Ralph (verified owner)

    I ordered this to fit on Games Workshop’s Warlord Titan, from the Adeptus Titanicus game. Dispatched swiftly and packed securely, everything arrived safely. Preparation was quick; there seemed to be no mould release to remove. There is a hint of 3D print lines visible on the surface, but this is subtle. A little light sanding would remove this very swiftly, but it’s barely noticeable anyway. The kit accepted spray primer well. Each banner is two-part; a neat design that gives you a small amount of variation to avoid duplicates. This size of banner fits well between the legs of the Warlord, required just a small dot of superglue on each end of the chain to fix it securely.
    The resin is good quality but brittle, so I suggest you use a sharp knife rather than clippers to remove the chain from the sprue tree.
    Overall, I’m very happy with the kit, and would recommend.

Only logged in customers who have purchased this product may leave a review.